Network Connection - Raymarine CP370 Installation Instructions Manual

4.5 Network connection

The unit must be connected to a compatible Raymarine multifunction display to enable echo sounder
data to be viewed.
Multifunction display connection
Unit connected to a multifunction display using a RayNet cable.
Note: The connection panel on your product may look slightly different to that shown, depending
on variant. The network connection method remains the same for all products featuring RayNet
connectors.
Item Description
1 Sonar module (CP370 illustrated).
2 Connector panel for compatible Raymarine multifunction display.
3 RayNet cable.
Multifunction display configuration (extended cables)
When the required length of a single network cable run is greater than 20 m (65.6 ft), a RayNet (male)
to (male) adaptor cable should be used to connect RayNet cables together .
Note: The connection panel on your product may look slightly different to that shown, depending
on variant. The network connection method remains the same for all products featuring RayNet
connectors.
62