Imo And Solas; Technical Accuracy; Operation Instructions; Multifunction Display Software Version - Raymarine CP370 Installation Instructions Manual

It is important that you register your product to receive full warranty benefits. Your unit package
includes a bar code label indicating the serial number of the unit. You will need this serial number
when registering your product online. You should retain the label for future reference.

IMO and SOLAS

The equipment described within this document is intended for use on leisure marine boats and
workboats NOT covered by International Maritime Organization (IMO) and Safety of Life at Sea
(SOLAS) Carriage Regulations.

Technical accuracy

To the best of our knowledge, the information in this document was correct at the time it was
produced. However, Raymarine cannot accept liability for any inaccuracies or omissions it may
contain. In addition, our policy of continuous product improvement may change specifications
without notice. As a result, Raymarine cannot accept liability for any differences between the product
and this document. Please check the Raymarine website (www.raymarine.com) to ensure you have
the most up-to-date version(s) of the documentation for your product.

Operation instructions

For detailed operation instructions for your product, refer to the documentation that accompanies
your display.
All product documentation is available to download from the Raymarine website:
www.raymarine.com/manuals.

Multifunction display software version

To ensure optimum performance and compatibility with external devices, your multifunction display
must be using the latest software version.
Visit www.raymarine.com

Suppression ferrites

• Raymarine cables may be pre-fitted or supplied with suppression ferrites. These are important for
correct EMC performance. If ferrites are supplied separately to the cables (i.e. not pre-fitted), you
must fit the supplied ferrites, using the supplied instructions.
• If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced
in the original position before the product is used.
• Use only ferrites of the correct type, supplied by Raymarine or its authorized dealers.
• Where an installation requires multiple ferrites to be added to a cable, additional cable clips should
be used to prevent stress on the connectors due to the extra weight of the cable.
12
to download the latest software.