Required Additional Components; Cp370: Emc Compliance - Raymarine CP370 Installation Instructions Manual

3.2 Required additional components

This product forms part of a system of electronics and requires the following additional components
for full operation.
• Compatible transducer: transom, through-hull, in-hull, or pocket/keel mount. Refer to the
Raymarine website for a list of transducers that are compatible with your sonar module:
www.raymarine.com/transducers. Refer to
restrictions that apply to transducers used with the CP370 sonar module.
• Compatible Raymarine multifunction display. Refer to
list of compatible products.
• Data cables. Refer to
may also require extensions to data, power or transducer cables. Refer to the
and connections and

CP370: EMC compliance

Important: To ensure EMC Compliance, the transducers listed below are NOT certified to be
used with the CP370 in the following regions:
• Australia;
• New Zealand;
• any member state of the European Economic Area (EEA);
• European Free Trade Association countries Iceland, Liechtenstein, Norway and Switzerland;
• any country that requires EMC Directive Compliance.
If in doubt, please contact your local dealer or Raymarine technical support.
Transducers NOT certified to be used with the CP370 in the regions listed above:
• E66054 (P66, Plastic, Transom mount)
• E66008 (P79, Plastic, In-hull)
• A66091 (B744V, Bronze, Through-hull)
• A66092 (B744VL, Bronze, Through-hull)
• E66013 (P319, Plastic, Through-hull)
• E66014 (B117, Bronze, Through-hull)
• E66085 (B60–20°, Bronze, Tilted element, Through-hull)
• E66086 (B60–12°, Bronze, Tilted element, Through-hull)
Planning the installation
CP370: EMC compliance
Chapter 4 Cables and connections
Chapter 10 Spares and accessories
for information about regional
Compatible multifunction displays
for suitable cables. Some installations
sections for more information.
for a
Chapter 4 Cables
29