Compass Safe Distance; Declaration Of Conformity; Connections To Other Equipment; Product Disposal - Raymarine CP370 Installation Instructions Manual

• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in the installation manual.
Note:
Where constraints on the installation prevent any of the above recommendations, always ensure
the maximum possible separation between different items of electrical equipment, to provide the
best conditions for EMC performance throughout the installation.

Compass safe distance

To prevent potential interference with the vessel's magnetic compasses, ensure an adequate
distance is maintained from the product.
When choosing a suitable location for the product you should aim to maintain the maximum possible
distance from any compasses. Typically this distance should be at least 1 m (3.3 ft) in all directions.
However for some smaller vessels it may not be possible to locate the product this far away from a
compass. In this situation, when choosing the installation location for your product, ensure that the
compass is not affected by the product when it is in a powered state.

Declaration of Conformity

FLIR Belgium BVBA declares that the following products are in compliance with the EMC Directive
2014/30/EU:
• CP370 Sonar module, part number E70297
• CP470 Sonar module, part number E70298
• CP570 Sonar module, part number E70258
The original Declaration of Conformity certificate may be viewed on the relevant product page at
www.raymarine.com/manuals.

Connections to other equipment

Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment using a cable not supplied by
Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.

Product disposal

Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE) Directive requires the recycling of waste
electrical and electronic equipment which contains materials, components and substances that may
be hazardous and present a risk to human health and the environment when WEEE is not handled
correctly.
Equipment marked with the crossed-out wheeled bin symbol indicates that the equipment
should not be disposed of in unsorted household waste.
Local authorities in many regions have established collection schemes under which residents can
dispose of waste electrical and electronic equipment at a recycling center or other collection point.
For more information about suitable collection points for waste electrical and electronic equipment in
your region, refer to the Raymarine website: www.raymarine.com/manuals.

Warranty registration

To register your Raymarine product ownership, please visit
Important information
www.raymarine.com and register online.
11