Table of Contents
Advertisement
Linear Force SmartLead
It is recommended that you redetect sensors in the hardware
configuration every time the SmartLeads are removed from the
Ultium sensor (redetection is necessary to revert to the use of the
sensor's EMG functionality). This will prevent configuration errors
leading to the inability to collect a measurement. If an error
message pops up when starting a measure, and you are using
SmartLeads, this is a good first troubleshooting step (1. Redetect
sensors in hardware set-up; 2. Double check the configuration). *
See Find My Sensor section below
P-802 Rev B (May 2019)
Step 3
Once back in the Home
screen, choose to create a
new or edit an existing
configuration.
Step 4
In the measurement setup
screen, insert the Ultium
system into the Devices in
your configuration box.
Step 5a
Once the Ultium system is
inserted, the muscle map
will appear to the left, and
the EMG channels and
sensors will appear below.
The Ultium Linear Force
should automatically
appear, as detected by the
Ultium system (if it does
not – refer back to step
2a).
11
Advertisement
Table of Contents
