Table of Contents
Advertisement
o Carefully turn the hob back over and then gently lower it into the
o There are holes on the base or the sides of the hob that you can
Downloaded from
www.Manualslib.com
o IMPORTANT:
o Carefully turn the hob upside down and
o IMPORTANT: Do not use a silicon sealant
aperture hole that you have cut out.
fix the four brackets to. There are three holes in each one of the
brackets.
manuals search engine
o IMPORTANT: You must observe
the
ventilation
shown in the drawing opposite.
There
holes around the outside of the hob.
YOU MUST ensure that these holes are
not blocked by the work top, when you
put the hob into position (see drawing
opposite).
place it on a cushioned mat.
to seal the appliance against the aperture.
This will make it difficult to remove the hob
from the aperture in future, particularly if it
needs to be serviced.
requirements
are
ventilation
23
Advertisement
Table of Contents
