Installation - Baxtran STI User Manual

USER MANUAL STI EN

4. INSTALLATION

UNPACKING
Carefully take the scale out of its package, make it sure its not damaged and all accessories are included.
Accessories:
1. Scale
2. Adaptor
3. Stainless steel pan
4. Product manual
Keep the packaging material for your future use.
LEVEL ADJUSTING
Place the scale on a table.
Check the water mark. If bubble is not centre, adjust the leveling feet until reach centre. Check the level when you change the
location.
CONECT ADAPTOR
• To charge the battery insert the adaptor pin to jack. Adaptor simply plug into the mains power.
The scale no needs to be turned on.
• The battery should be charged for 4 hours for full capacity.
• The symbol status of the battery
Battery voltage has dropped
Fully charged
• Do not use any other type of power adaptor than the one supplied with the scale.
• Verify that the AC power socket outlet is properly protected
INSTALLATION
• Place the scale on a table.
• Insert the pole into the bottom bracket.
• Close the bottom cover by using screws
• Carefully place the pan to the four holes on the top cover
• Adjust the water mark bubble level.
• Connect the adaptor pin to the adaptor jack.
Adaptor jack is locating below the right side of the scale.
8