Connecting the Optional External Buzzer
When using the optional external buzzer (OT-BZ20), install the optional external buzzer.
If your printer is not equipped with a buzzer, you can use the optional external buzzer (OT-BZ20) by
connecting it to the drawer.
• The optional external buzzer and the drawer cannot be used together at the same time.
• If you configure the memory switch setting to enable the optional external buzzer, the drawer
• Make sure to use the accessory affixing tape to attach the optional external buzzer to the
• Be careful not to spill water, oil, solvent, or any other liquid over the printer. Doing so may
Unpacking
Open the package and confirm that it contains all of the parts listed in the illustration. If any parts are missing
or damaged, please contact your dealer for assistance.
Optional external buzzer
Installation Position
This product is recommended to be installed in the following position.
• Either side of the printer.
• Do not install the optional external buzzer at the roll paper exit.
• To prevent liquid from entering inside, it is recommended to install the optional external
42
cannot be opened because the pulse is not sent to the drawer kick connector pin.
printer.
result in malfunction of the printer.
buzzer so that the volume adjustment knob is positioned sideways or downward. (For details
of the volume adjustment knob, see
Affixing tape
(1 pair, 2 pieces)
User's Manual
"Adjusting the Buzzer Volume" on page
44.)