Tesla 32S357SHS Operating Instruction page 18

ENG
Step 1 Press MENU button and select INSTALLATION menu. Select DVB-S/S2 auto
tuning and press OK button, the screen will show as Fig1, and the default satellite will
be highlighted.
Step 2 Press OK button to confirm the selected satellite.
Step 3 Press button to switch to LNB setting, press button to highlight LNB Type
and press OK button to set up this parameter.
Step 4 Check if the 22KHz Tone, DiSEqC1.0/1.1 is corresponding to the selected
satellite, if not, highlight and press OK button to set up the right parameter. (Refer to Fig 2)
After the above steps are finished, press the blue button to search for channels.
• DVB-T/T2 or DVB-C or ATV Auto Tuning
Select DVB-T/T2 (or DVB-C/ ATV) Auto Tuning to search the programs automatically Before
searching, you may need to select the country or set up the scan menu. If you want to stop
the auto search, press MENU or EXIT button, a exiting dialog is popped out.
• Press  to confirm exit.
• Press  to continue searching.
DVB-T/T2 or DVB-C Manual Tuning
Search and store programs manually, first select the corresponding source before starting
search.
1. In Installation menu, select DVB-T/T2 (or DVB-C) manual tuning and press OK to access
the searching interface, first select the country.
2. Second press  or  to set up relevant parameters such as scan mode, scan scope etc.,
and then select Search and press or to start the search.
3. The search stops when a program is found and this program will be stored in the current
channel position. If you want to stop the search, press MENU button.
Fig. 2
18