Table of Contents
Advertisement
3.2.4
Connecting the wastewater system
Multiplex drain/overflow functional unit
Requirements:
The overflow is mounted in the overflow opening.
n
The drain is securely mounted on the base of the bathtub.
n
NOTICE! Connections where the pipes are not inserted far
enough into each other become leaky. For this reason, maintain
a minimum insertion depth of 15 mm for every connection.
Mount union nut, sliding ring and seal.
Screw together overflow and extension pipes.
Maintain an insertion depth of at least 15 mm!
Hold the pipe of the overflow unit parallel to the overflow pipe and
mark the positions where the drain and the overflow should be con-
nected.
Maintain an insertion depth of at least 15 mm!
Cut the overflow pipe to the marked length and, if necessary,
deburr.
Push the top end of the overflow pipe into the rubber sleeve.
Maintain an insertion depth of at least 15 mm!
Push the union nut, sliding ring and seal onto the bottom end of the
drain elbow.
Screw the union nut on the drain unit.
Proceed as follows to connect the drain/overflow to the wastewater
system:
Handling
13 from 17
Advertisement
Table of Contents
