Related Manuals for Viega Advantix 4982.45
Summary of Contents for Viega Advantix 4982.45
- Page 1 Advantix shower channel mounting frame Instructions for Use For mounting with an Advantix shower channel Model 4982.45 en_INT...
- Page 2 Advantix shower channel mounting frame 2 from 9...
-
Page 3: Table Of Contents
Table of contents Table of contents About these instructions for use Target groups Labelling of notes About this translated version Product information Standards and regulations Product description 2.2.1 Overview of the components Handling Assembly information 3.1.1 Important note 3.1.2 Installation dimensions Assembly Disposal Advantix shower channel mounting frame... -
Page 4: About These Instructions For Use
This restriction does not extend to possible operating instructions. The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use. -
Page 5: About This Translated Version
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e. -
Page 6: Product Information
2 Product information Standards and regulations The following standards and regulations apply to Germany / Europe. National regulations can be found on the relevant web site of your viega.com/standards . country at Regulations from section: Media Scope / Notice Regulations applicable in Ger-... -
Page 7: Handling
Handling 3 Handling Assembly information 3.1.1 Important note During assembly: Observe installation dimensions. After assembly: The shower channel must be fully lined with mortar. Coordinate all relevant installation details, especially regarding the bonded sealing, with those responsible for the subsequent work. 3.1.2 Installation dimensions Fig. -
Page 8: Assembly
Handling Assembly Requirements: The shower channel has been mounted according to the instructions for use. The complete surface of the shower channel has been lined. The shower channel has been sealed, and the thin bed sealing is fully cured. The shower channel is equipped with a protective insert. Apply the tile adhesive. -
Page 9: Disposal
Handling Remove the protective insert. 589379_B4 If a gap has formed at the inside of the shower channel, seal it with tile adhesive or joint filler. 589379_B4 Regarding mounting of the grate, refer to the instructions for use for the grate. Disposal Separate the product and packaging materials (e.