Toshiba RAV-RM2801DTP Series Service Manual page 93

No. Part name
⑦ Drain pan
1. Detachment
1) Remove the drain hose or drain cap and then
extract the drain water accumulated in the drain pan.
NOTE
When removing the drain hose or drain cap, be sure
to take the drain water with a bucket, etc.
2) Remove the screw A fixing the bottom plate.
(9 positions)
Loosen the screw B. (4 positions)
3) Slide the bottom plate (drain side) to the arrow
direction and then remove the panel.
4) Loosen the screw of the drain pan supporter, and
turn the drain pan supporter.
5) Lower the drain pan of the drain socket side, and
remove it to the arrow direction slowly.
CAUTION
When removing the drain pan, do not hold the
drain socket. (Water leakage may occur.)
2. Attachment
1) Put back the drain pan, and turn back the drain pan
supporter and fix it with the screws.
2) Attach the bottom plate (drain side) to the original
position.
⑧
Sensor 1. Detachment
Perform 1 of ① to remove the electrical parts box cover.
TC, TCJ
1)
2) Loosen the fixing screws of the inspection cover and
remove the inspection cover.
3) Remove the connectors of the wires of TC sensor and
TCJ sensor from the control P.C. board.
CN101 : TC sensor (2P, Black)
CN102 : TCJ sensor (2P, Red)
4) Remove the sensor from the
sensor holder.
2. Attachment
1) Attach the TC sensor and TCJ sensor to the original
position.
2) Attach the inspection cover as before.
3) Attach the wires of TC sensor, and TCJ sensor as
before.
4) Attach the electrical parts box cover as before.
Procedure
TC Sensor
TCJ Sensor
CN101 CN102
sensor clip
sensor holder
Control P.C.board
MCC-1643
- 93 -
Remarks
Bottom plate (Drain side)
Screw A
Drain pan supporter
Drain pan pull-out
direction.
Drain pan
Screw
Inspection cover
Screw B
Drain
socket
TCJ sensor
(Red)
TC sensor
(Black)