Rp3181 Rod-End Re-Termination Procedure - SPX Pearpoint P330+ Series Service Manual

5.1. RP3181 Rod-End Re-termination Procedure

Examine the full length of the rod for damage, particularly any penetration of the outer sheath or
kinking.
Cut off the old termination including any damaged rod.
Slide the Shroud nut, Taper nut, Thrust washer, Nylon collet (narrow-end towards taper nut), O-
ring washer (with flat surface towards nylon collet, taper side towards O-ring) and the 12mm O-
ring onto the termination end of the rod.
Copyright 2012 Radiodetection Ltd.– SPX Corporation. All rights reserved. Radiodetection is a subsidiary of SPX Corporation.
This document may not be copied, reproduced, transmitted, modified or used, in whole or in part, without the prior written consent of Radiodetection
Ltd. We reserve the right to alter or amend any published specification without notice.
Remove 11mm of the outer
insulation from the rod. Remove
the Kevlar braid.
Trim it as close to the black outer
sheath as possible.
Page 27 of 59