P342 Or Gatorcam 4 Midi Reel (60M/200' Or 120M/400'); 10/Rp2809 - SPX Pearpoint P330+ Series Service Manual

6. P342 or Gatorcam 4 Midi Reel (60M/200' or 120M/400')

Rod Camera-End Retermination
Materials required, one of:-
Rod Re-termination Kit (Full)
Rod Re-termination Kit (Partial)
Rod Re-termination Kit (Basic)
.
Slipring Re-termination Kit
See Bill-of-materials and drawings later in this chapter to confirm what you need.
These instructions detail the re-termination procedures for both the P342 and GatorCam4 Midi
60m/200' and 120m/400' reels. Ensure that you read and understand these instructions in full
before proceeding.
There are two versions of the P332 rod termination, version 8A and version 9.
The P342 rods use only the version 9 termination.
They can be identified by checking the clamp nut (8A)/taper nut (9).
The clamp nut of version 8A has two flats and the taper nut of version 9 has a hexagonal head.
1) Shroud nut, 2) clamp nut, 3) thrust washer, 4) connector clamp ring (olive), and 5) rod
The Bill of Materials and General Assembly drawings are at the end of this section.
Copyright 2012 Radiodetection Ltd.– SPX Corporation. All rights reserved. Radiodetection is a subsidiary of SPX Corporation.
This document may not be copied, reproduced, transmitted, modified or used, in whole or in part, without the prior written consent of Radiodetection
Ltd. We reserve the right to alter or amend any published specification without notice.

10/RP2809

10/RP2809-2
10/RP2809-3
10/RP2809-4
Discontinued version
connector.
Current version
(replaces all parts)
(re-uses original slipring PCB)
(re-uses slipring PCB, rod connector, collet
and Shroud nut)
(slipring assembly only, includes circlip)
10/RP2809
Page 37 of 59