2. Tools & Equipment
Some or all of the following tools will be required depending on which re-termination is being done :-
Junior Hacksaw (150mm / 6")
Fine wire cutters / Adjustable precision wire stripper, 0.25-0.80mm.
Triple-action cable stripping tool, 4.5-29mm strip
Scalpel / craft knife
Heatgun appropriate for small heatshrink applications (see pictures)
Scotchweld
Digital Volt Meter
Soldering iron \ Solder
Pressure test Jig Part: 09/RP3210Z2 with regulated airline or foot pump with
pressure gauge
15mm & 16mm open-ended spanners
Open-ended torque spanner with 15mm/16mm heads
Internal circlip pliers
"C" Spanner
Special Tools:-
Dual Size "C" Spanner,
- Available from Pearpoint / Radiodetection, part number 70/GC2011N14
Copyright 2012 Radiodetection Ltd.– SPX Corporation. All rights reserved. Radiodetection is a subsidiary of SPX Corporation.
This document may not be copied, reproduced, transmitted, modified or used, in whole or in part, without the prior written consent of Radiodetection
Ltd. We reserve the right to alter or amend any published specification without notice.
®
(such as RS
Stock No. 622-721)
{such as Tavismanor ROT29RTGRS01/001 (RS Stock No. 262-0151)}
®
DP100 needle applicator
Torque wrench
Typical wire stripper
Page 4 of 59