Configuring The Card; Setting The Position In The Pc/104 Stack - Peak PCAN-PC/104-Plus User Manual

PCAN-PC/104-Plus – User Manual
2

Configuring the Card

Before installing the PCAN-PC/104-Plus card into a PC/104 stack, you
may have to configure it using jumpers and solder bridges on the
PCB.
2.1 Setting the Position in the PC/104
Stack
Tip: If you are going to use the PCAN-PC/104-Plus card plucked
as first card onto the host (without any further PC/104 cards in-
between), you can skip the configuring of the position and
directly continue with the
delivery the PCAN-PC/104-Plus card is already configured
accordingly.
For communication with the host the PCAN-PC/104-Plus card uses
the PCI interface where specific relations between the lengths of the
signal lines must be met. Different line lengths result from different
positions of a PC/104-Plus card in a PC/104 stack. Therefore the
PCAN-PC/104-Plus card must be adjusted to a specific position in
the stack by setting the appropriate jumpers. The spatial distance to
the host results in the index for the assignment of the jumpers.
following manual section
6
2.2. At