Fabricate Head, Horizontal & Sill Members; Fabricate Glass Stops & Glazing Adaptors - Ykk ap YES 45 FS Installation Manual

YES 45 FS/FI Storefront System
STEP 3
FABRICATE HEAD, HORIZONTAL & SILL MEMBERS
-Cut head, sill and horizontal members to the daylight opening between verticals.
-Members that are to be attached to shear blocks require additional fabrication:
Head Members: Mark a hole location at each end, 1" from the ends
centered along the glazing pocket "V"-groove.
YES 45 FS horizontal and sill members:
Mark a hole location at each end, 1" from the ends
centered along the glazing pocket "V"-groove.
YES 45 FI horizontal and sill members:
Measure up 1/4" from the glazing pocket and
mark a hole location at each end, 1" from the ends.
-Drill a 0.236" diameter hole (# B drill bit) at each
location marked.
See Detail 6.
0.236" Dia.
1"
Horizontal/Sill
STEP 4
FABRICATE GLASS STOPS & GLAZING ADAPTORS
-Cut glass stops to the same dimensions as their respective horizontals minus(–) 1/32".
YES 45 FI only:
-Cut vertical glazing adaptors to the frame height.
-Cut horizontal glazing adaptors to the daylight opening minus(–) 1/32".
Effective Date: May 29, 2018 | 02-4001-09
FRAME FABRICATION
"V"-groove
YES 45 FS
0.236" Dia.
YES 45 FI Head Shown
Detail 6
1"
Others Similar
1"
0.236" Dia.
YES 45 FI
Horizontal/Sill
"V"-groove
Page-11