Omron NY Series Operating Manual page 118

7 Maintenance
4
Select the Setup Button.
An empty screen appears with only the message Touch this screen to identify it as the
touchscreen. If this is not the Table PC screen, press Enter to move to the next screen. To
close the tool, press Esc.
5
Select Enter to move the message to the connected monitor with touch functionality.
6
Touch the screen to indicate it is the correct monitor with touch functionality.
The message appears Press Enter to proceed to the next step to complete your configuration.
7
Select the Enter key.
8
Check the touchscreen functionality.
Calibrate the touch functionality if the touch indicator does not appear at the location that you
touch.
Refer to Calibrate Touchscreen on page 7-34 for calibration details.
The touchscreen functionality is available on the correct monitor.
7-36
NY-series Industrial PC Operating Systems and Software Utilities Manual (W616)