Point And Activate Terminal With Wireless Device - Hughes Jupiter Pointing Manual

Point and activate terminal with wireless device

Chapter 4 • Pointing the antenna by using a wireless device
40
1039429-0001 Revision D
3. Access the wireless router's built-in web server by entering
URL field of an Internet browser on your laptop.
4. Log in to the Netgear router with the following credentials:
Username:
admin
Password:
password
Note: Other routers may use different values.
5. Click Wireless Settings on the left side of screen.
6. Change SSID to
HughesOasis
7. Click Apply. The router may ask you to enter your username and password
again. Use the same as above and click OK.
8. Disconnect the Ethernet cable from the laptop.
1. Plug the Ethernet cable from the satellite modem into the WAN port on
wireless router, as shown in
Figure 22: Connecting the satellite modem and Wi-Fi router
2. Plug in the power cord of the Wi-Fi router.
3. On your wireless device, search for available Wi-Fi signals.
4. Continue with Chapter 3 or Chapter 4, depending on the DAPT version being
used.
5. Launch an Internet browser on the wireless device and enter
URL field. The System Control Center (SCC) should now be displayed, as shown
in Figure 23 on page 41.
6. Click the Information icon on the right side of the System Information link.
.
Figure 22.
Ethernet cable
in the
10.0.0.1
in
192.168.0.1