Table of Contents
Advertisement
Chapter 2 • Pointing the antenna
12
1037663-0001 Revision A
Figure 6: Terminal Pointing Info screen
Note: The initial SQF value listed on this screen will most
likely be either 0 or 1, indicating that the demodulator is either
initializing or searching for a beacon signal, respectively.
Once the demodulator acquires the beacon signal, the SQF
value will be greater than 1.
9. Make a note of the following values shown on this screen.
You will need this information to point the antenna and
complete the installation.
– Azimuth
– Elevation
– Tilt angle (.74m antennas only)
– ODU polarization setting (LHCP or RHCP).
Note: This is the true polarization setting. Ensure that the
polarizer on the antenna radio matches this setting.
Advertisement
Table of Contents
