Hughes Jupiter Pointing Manual page 33

Note: Do not disconnect the DAPT3 until instructed to do so. Disconnecting
the DAPT3 prematurely could cause a loss of all stores data,
invalidating the entire pointing process. It could also cause the
satellite router to crash.
2. Press Advance (3) to save the pointing validation results, or Back (1) to return
to the previous state.
If you press Toggle (2), the DAPT3 display reads:
This indicates that you have completed the pointing process successfully. The
DAPT3 displays this message for approximately 10 seconds and then displays
the IFL voltage to indicate that the pointing process has finished.
Note: Do not disconnect the DAPT3 until the IFL voltage disappears.
Disconnecting the DAPT3 prematurely could cause a loss of all stored
data, invalidating the entire process.
3. Disconnect the DAPT3.
4. Ensure the TX IFL Voltage field on the satellite modem's registration screen
(Figure 18 on page 33) displays the correct value – either On or Off –
depending on the type of installation you are performing.
Figure 18: TX IFL voltage on satellite modem registration screen
5. Reconnect the IFL cable directly to the radio.
6. Weatherproof all outdoor cable connections with dielectric grease. Depending
on your installation environment, weatherproofing tape may also be needed,
as shown in Figure 20
Note: If you use any cable ties, they must be resistant to ultraviolet rays.
on page 35.
Chapter 3 • Pointing the antenna by using the DAPT3
1039429-0001 Revision D
33