Chapter 2 Safety Information; Electrical Shock Hazard; Installation And Operation - VCS Videojet Series Manual

Safety information

Electrical shock hazard

Have the system checked by VCS in such cases.

Installation and operation

VideoJet
Never attempt to connect the unit to any power network other
than the one for which it was intended.
Use only the mains lead supplied.
Do not open the housing of the power supply unit.
Disconnect the power supply unit from the mains power supply
and from all other devices if a fault occurs.
Install the power supply unit and server only in a dry place pro-
tected against the elements.
If you are uncertain about the safe operation of the unit, shut it
down immediately and secure it to prevent any unauthorised
start-up. Safe operation is no longer possible, for example,
– if damage is visible to the server of the cables,
– if the server no longer operates correctly,
– if the server has been exposed to rain or moisture,
– if objects have penetrated inside the server,
– after long storage under improper conditions or
– after heavy demands during transport.
All applicable electrical codes and regulations must be observed
and followed at all times during the installation.
2
11