Relay Configuration - VCS Videojet Series Manual

Configuration with web browser

Relay configuration

You can configure the switching behaviour of the relay output. You
can assign the relay the function of an NC contact (closed at zero
current) or an NO contact (open at zero current).
Furthermore you can specify whether the output reaction is to be
bistable or monostable. In bistable mode, the triggered status of the
relay is maintained. In monostable mode, you can set the time after
which the relay is to return to its non-activated state.
You can select various events for the output which automatically
activate the output. It is thus possible, for example, to switch on a
floodlight when a motion alarm is triggered and to switch off the
floodlight again at the end of the alarm.
Relay action Idle state:
Select Open if the relay is to function as an NO contact or Closed
if the relay is to function as an NC contact.
Operating mode:
Select an operating mode for the relay.
44
VideoJet