Chapter 7 Care And Service; Checking The Network; Maintenance - VCS Videojet Series Manual

Care and Service

Checking the network

The connection between two IP addresses can be checked using
the command
in the network is active.
Open the DOS input window
Enter the command
VideoJet .
When the
from ...
transmission time in ms. Otherwise the
addressed via the network. This can have the following causes:

Maintenance

Attention!
Never open the housing of the
devices contain no parts which you can repair or replace.
Ensure that only qualified, specialist personnel (electrical techni-
cians) are permitted to carry out maintenance or repair work or con-
tact the VCS Service centre.
VideoJet
. You can thus check whether the
ping
ping
VideoJet is found, you receive in response:
, followed by the number of bytes transmitted and the
The VideoJet is not correctly connected to the network. In this
case, check the connecting leads.
The VideoJet is not correctly integrated into the network.
Check the IP address, the subnet mask and the gateway IP.
followed by the IP address of the
VideoJet cannot be
VideoJet or power supply unit. The
7
VideoJet
Reply
61