System Control - Raymarine H6 System Installation Manual

Installation
To remove thetransit securing clips:
1. Remove the top cover of the computer.
Transit
securing clip
2. Locate the transit securing clip which is located to the right of the CD drive when
the computer is viewed from the front.
3. Remove the transit securing clip by pulling it upwards and awayf rom the shock
mounting.

System control

The normal operating sequence for H6 requires power to be applied to the system by
pressing the on/off button on the front of the navigation computer. If the computer and
interface units are installed some way from the helm (e.g. on another deck) this is not
always easy or practical. Consideration should therefore be given to installing a
remote power switch at the main helm which can be used as an alternative to the
computer button.
Installation of this will require a cable to be run from the navigation interface unit -
CON 29 and terminate in a suitable ON/OFF switch at the helm. This switch must be
clearly annotated as to its purpose.
D7660_1
Main helm
Navigation computer
27
Remote ON/OFF
switch