Raymarine H6 System Installation Manual page 66

60
Lifeline
Problem
Cannot register a specific Lifeline tag
Cannot activate any Lifeline tag
Lifeline data box shows ' Lifeline Offline' message
Lifeline MOB alarm activates as tags are carried
around boat
Cannot register a tag after a system reboot
All tags show 24 hours to expiry even though this is
not correct
Lifeline shows 'Man Overboard' alarm on opening
Trackball
Problem
Cursor stops following the trackball
Entertainments system
Problem
Audio-visual control unit will not accept a disk.
Power amplifier (not the speakers) makes a
continuous clicking noise.
Cannot view navgation screen on entertainments
screens.
Etertainment screen does not change from Nav 1 to
Nav 2
Entertainments do not respond to remote control
Message ' Audio system not responding' appears on
screen.
No sound from a center or rear speaker
No sound from a speaker
Remote control unit screen is blank
Raymarine H6 - System Installation Manual
Possible solution
Replace the tag battery See "Replacing a transmitter battery" on
page 63.
1. Check antenna are correctly installed and connections are
correct.
2. Make sure tags are correctly seated in the Lifeline receiver.
Check cable connections between computer and interface units.
Incorrect Lifeline antenna coverage. Check antenna locations,
orientation and connections are correct.
Lifeline needs to detect activated tags. Click 'Reset Lifeline', a
message asking if you want to register detected tags will be
OK
displayed. Click , you will now be able to register a new tag.
This usually occurs after a system reboot. De-activate all tags and
re-activate them.
Computer, not H6 system has been shut down. Click 'Reset
Lifeline'. Alarm will be cancelled and Lifeline system will reset.
Possible solution
Move the trackball more slowly. The cursor will then follow.
Possible solution
1. Check tha t the unit is turned on.
2. Press the eject button in case there is already a disk in the unit.
Check amplifier input voltage and power requirements are being
met.
Check cable computer and interface connections.
Check nav interface to ents interface comms cable connections.
1. Make sure the remote is pointed towards the AV control unit.
2. Check batteries in the remote control unit do not require
replacing.
Check all computer and interface connections.
Check DVD/CD disk is 5.1 audio.
1. Check volume settings.
2. Check 5.1 audio cable and connections
Change the batteries.
.