Operation - Silvercrest STV 45 C2 Operating Instructions Manual

RP96066 Tower-Ventilator LB4 Seite 7 Donnerstag, 10. Oktober 2013 11:00 11
6.1 Start and switch off the appliance
1. Plug the power plug into a power supply
socket which meets the technical data
requirements (see "3. Technical data"
on page 4).
2. Switch on the power
supply by turning rotary
switch 2 to "ON".
The appliance is now operational.
3. Switch off the power
supply by turning rotary
switch 2 to "OFF".
6.2 Set blower setting
The blower settings are used to select how
fast the appliance circulates air in the room.
The appliance has three blower settings:
– 1, low: press button 6;
– 2, moderate: press button 4;
– 3, high: press button 3.
Press the 7 "OFF" button to stop the
appliance working.
STV 45 C2

6. Operation

6.3 Set running time
The appliance has a timer which you can
use to set the desired running time to
between 0 and 120 minutes.
1. Switch on the timer by
turning rotary switch 2 to
any time between 0 and
120 minutes. The power
supply is switched on at
the same time.
2. To switch off the timer, set rotary
switch 2 to "OFF".
Note If you want the appliance to operate
continuously, set rotary switch 2 to "ON".
6.4 Oscillation function
The appliance has an oscillation function.
This causes the appliance to move to and
fro, distributing the air produced evenly
throughout the room.
1. Switch on the oscillation function by
pressing oscillation function key 5.
2. Switch off the oscillation function by
pressing oscillation function key 5 again.
7