ABB AC 800M Installation Manual page 47

Section 2 Transmission Media and Components
The nodes connecting to the DeviceNet with a connector must have male pins.
This is applicable to the sealed, unsealed connectors, and all nodes that consume
or supply power.
Device removal must be possible without severing or disturbing the network,
regardless of the chosen connector solution.
Do not install wires while the network is active. This can effect network supply
shorting or cause communication disruption.
Figure 14
Figure 14. Open Connector Profile
9ARD000015-600
shows the pinout details of a open connector.
Network Connector (Female Contacts)
5 V+
4 CAN H
3 drain
2 CAN L
1 V-
Device Connector (Male Contacts)
Connectors
red
white
bare
blue
black
47