ABB AC 800M Installation Manual page 31

Section 2 Transmission Media and Components
Table 19. Physical Characteristics of General Specification for Thin Cables
Physical Characteristics
Geometry
Overall braid shield
Drain wire
Outside diameter
Roundness
Jacket marking
Table 20. Electrical Characteristic of General Specification for Thin Cables
Electrical Characteristic
DCR (braid+tape+drain)
Table 21. Environmental Characteristics of General Specification for Thin Cables
Applicable Environmental
Characteristics
Agency Certifications
Flexure
9ARD000015-600
Specification
Two shielded pairs, Common axis with
drain wire in center.
65% coverage. 0.12 mm (36 AWG)
tinned Cu braid minimum
(individually tinned)
#22 Copper 19 Strands minimum
(individually tinned)
0.240 inches (minimum) to 0.280 inches
(maximum)
Delta to be within 20% of 0.5 O.D.
Vendor Name & Part #, and additional
markings
Specification
3.2 Ohms/1000 ft (nominal @ 20° C)
Specification
According to Federal, State and Local
regulations.
2000 cycles at bend radius, 90 degrees, 2 lb.
Pull force, 15 cycles per minute, Tic Toc or C
track method
Thin Cable
31