: Thread the other end of the rope,
from outside, through the guide
bushing in the fan housing.
: Thread the end of the rope
through the hole in the side of the
rotor, pull it out.
– Secure the rope with a simple
overhand knot.
: Pull rope back until knot locates
in recess (arrow) in rope rotor.
– Tension the rewind spring –
b 8.6
60
8.6
Tensioning
the Rewind Spring
– Remove the fan housing with
rewind starter – b 8.2
– Relieve tension of rewind spring
– b 8.4
: Make a loop in the starter rope.
: Grip the rope next to the rotor and
use it to turn the rope rotor six
times clockwise.
: Hold the rope rotor steady.
: Pull out the rope with the starter
grip and straighten it out.
– Hold the starter grip firmly to keep
the rope tensioned.
– Let go of the rope rotor and
slowly release the starter rope so
that it can rewind properly.
MS 650, MS 660