Table of Contents
Advertisement
Pressure range
Operating temperature
Recommended transport and storage temperature
4. Safety instructions
In addition to the information relevant to safety
given in each of the sections of these operating
instructions, the following points must be strictly
observed at all times.
4.1 Requirements to be met by users
Stay alert, watch what you are doing and use com-
mon sense when working. Do not use the tool while
tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating
tools may result in serious personal injury.
4.2 Proper organization of the workplace
a) Ensure that the workplace is well ventilated.
b) Ensure that the workplace is well lit.
c) Keep the work area tidy. Any objects which may
cause injury should be removed from the area.
Untidiness at the workplace can lead to accidents.
d) Keep children and other persons away from
the area while the tool or appliance is in use.
Distractions can cause you to lose control.
e) Avoid unusual body positions. Make sure you
work from a safe stance and stay in balance at
all times.
f) In order to avoid presenting a tripping hazard
while working, always lead the compressed-air
hose away to the rear of the tool.
g) When working on a scaffold, the tool must be
secured to prevent it falling.
4.3 General safety instructions
a) Operate the tool only as intended and when it is
in faultless condition.
b) Always hold the machine securely with both
hands on the grips provided. Keep the grips
dry, clean and free from oil and grease.
c) Never leave the appliance unattended.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070005 / 000 / 00
1.0 kN to 6.25 kN
+5...+40°C (40 to +104°F)
+0...+40°C (32° to +104°F)
d) Avoid accidental starting. Disconnect the tool
from the air supply during breaks between work-
ing, in the event of malfunctions and before
cleaning.
e) Never point the tool toward yourself or other
persons.
f) Always concentrate on your work. Think care-
fully about what you are doing and do not use
the tool if you are unable to concentrate.
g) Use only cartridges of a type designed and
approved for use with the tool.
h) Do not attempt to open or disassemble the tool.
i) If the compressed-air hose is damaged, have it
replaced by Hilti Service.
j) Maintenance may be carried out only by Hilti
Service.
k) Do not use soiled or damaged cartridges.
l) The front plate and piston plates must be kept
clean and free from foreign matter.
m) The mixer may be changed only when the car-
tridge is not under pressure (the piston advance
button not pressed).
n) The mixing nozzle must be changed if the mortar
inside has hardened during a break between
periods of use.
4.4 Power tool use and care
a) The tool may be operated only when in faultless
condition.
b) Use only cartridges of a type approved for use
with the tool.
c) Do not use damaged cartridges.
d) The tool must not be under pressure when
changing the cartridge or the mixing nozzle.
e) The cartridge holder and pistons must be clean
and free from foreign matter.
f) Do not attempt to open or disassemble the tool.
Repairs may be carried out only by Hilti Service.
en
3
Advertisement
Table of Contents
