Table of Contents
Advertisement
instructions for use. This initial quantity must also
be discarded after changing a mixing nozzle.
WARNING
Begin dispensing mortar only after the mixer has
been screwed on.
CAUTION
The tool / cartridge must not be under pressure
when changing the mixing nozzle.
NOTE
Mortar in the mixing nozzle hardens if dispensing is
interrupted for a long period. Screw on a new mixing
nozzle when you wish to continue dispensing from
the cartridge.
1.
Adjust the regulating wheel to set the pressure
required for the desired dispensing rate.
NOTE Eight settings between minimum and max-
imum are possible.
2.
Press the trigger to begin dispensing the mortar.
3.
Release the trigger when you wish to interrupt
or stop dispensing.
NOTE The built-in rapid pressure compensation
system reduces subsequent dripping of mortar
from the dispenser to a minimum.
NOTE Please refer to the instructions for the
cartridge for further information about use of the
mortar.
7. Care and maintenance
CAUTION
In order to prevent unintentional operation, discon-
nect the tool from the compressed-air supply and
remove the mortar cartridge before cleaning the tool
or before carrying out maintenance.
7.1 Care and maintenance of the tool
CAUTION
Keep the appliance, especially its grip surfaces,
clean and free from oil and grease. Do not use
cleaning agents which contain silicone.
Apply a few drops of acid-free compressed-air oil to
the inside of the compressed-air connector each day.
Check the condition of the piston regularly and replace
it if found to be worn or damaged.
Mortar adhering to the tool must be cleaned off with
a cloth as quickly as possible before it hardens.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070005 / 000 / 00
6.4 Removing/changing the cartridge 5
WARNING
Risk of pinching the fingers! Keep your hands away
from the area of the pressure pistons.
NOTE
Store partly-used cartridges with a mixing nozzle
screwed on. Partly-used cartridges have a limited
shelf life. Please refer to the instructions for use of
the product.
1.
Press the piston retraction button and allow the
piston rods and pistons to retract.
2.
Open the latch at the front end of the cartridge
holder.
3.
Grip the cartridge at the mixing nozzle and lift it
out of the tool.
4.
Close the latch.
6.5 Disposing of cartridges
CAUTION
Dispose of empty cartridges in accordance with the
official national regulations.
For information about disposing of full, partly-used
and completely empty cartridges, please refer to the
instructions for use of the product or the applicable
safety data sheets.
NOTE
Hardened mortar can be removed only by mechanical
means. Take care to ensure that the tool is not
damaged in the process.
Clean the outside of the tool at regular intervals with
a slightly damp cloth. Do not use a spray, steam
pressure cleaning equipment or running water for
cleaning. Never dip or soak the tool or its parts in
solvents.
7.2 Checking the tool after care and
maintenance
After cleaning or carrying out maintenance, check
that moving parts function faultlessly, that no parts
are sticking, broken or damaged and that the tool
operates faultlessly.
en
5
Advertisement
Table of Contents
