Description; Technical Data; Safety Instructions - Hilti HTE-P33 Operating Instructions Manual

Symbols
en Read the Return waste
operating material for
instructions recycling.
before use.

2 Description

2.1 Use of the product as directed
The tool is designed to be used for dispensing the con-
tents of Hilti HTE 50 two-component cartridges with a
volume of 33 fl.oz.
The appliance is designed for professional use and may
be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed
of any special hazards that may be encountered. The ap-

3 Technical data

Right of technical changes reserved.
Tool without cartridge
Weight (without mortar)
Dimensions (L x W x H)
Input pressure
Air consumption
Pressure range
Operating temperature
Recommended transport and storage temperature

4 Safety instructions

In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.
4.1 Requirements to be met by users
Stay alert, watch what you are doing and use common
sense when working. Do not use the tool while tired or
under the influence of drugs, alcohol or medication.
A moment of inattention while operating tools may result
in serious personal injury.
2
National
waste
material
recycling
system
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the appliance. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Generation: 01
Serial no.:
pliance and its ancillary equipment may present hazards
when used incorrectly by untrained personnel or when
used not as directed.
Modification of the appliance or tampering with its parts
is not permissible.
To avoid the risk of injury, use only genuine Hilti tools and
accessories.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
3.9 kg (138 oz)
600 mm x 120 mm x 300 mm (23.6 x 4.7 x 11.8 ")
max. 8 bar (116 PSI)
max. 40 l/min. (10.57 gal./min.)
1.0 kN to 6.25 kN
+5...+40°C (40 to +104°F)
+0...+40°C (32° to +104°F)
4.2 Proper organization of the workplace
a) Ensure that the workplace is well ventilated.
b) Ensure that the workplace is well lit.
c) Keep the work area tidy. Any objects which may
cause injury should be removed from the area.
Untidiness at the workplace can lead to accidents.