Table of Contents
Advertisement
4.5 Personal protective equipment
en
a) Wear personal protective equipment while the
tool is in use: closely fitting protective glasses
5. Before use
WARNING
Risk of pinching the fingers! Keep your hands away
from the area of the pressure pistons.
6. Operation
6.1 Preparing a cartridge for use 2
CAUTION
Read and observe the safety data sheet for the
product before using it. Read the label and instruc-
tions for use of the product before using it. Check
the expiry date on the cartridge label. Use of the
product after the expiry date is not permissible.
CAUTION
The cartridge must be checked for damage if it has
been dropped or subjected to a hard impact. Never
use damaged cartridges.
CAUTION
When in use, the temperature of the cartridge must
not fall below the minimum temperature given in
the instructions for use of the product.
1.
Remove the cap and the plug from the cartridge.
2.
Screw the HTE M mixing nozzle fully onto the
thread on the cartridge.
NOTE A new mixing nozzle should be used with
each new cartridge.
4
Printed: 07.07.2013 | Doc-Nr: PUB / 5070005 / 000 / 00
or face shield, protective gloves and protective
clothing. Wearing personal protective equipment
reduces the risk of injury.
b) Persons in the immediate vicinity must also
wear personal protective equipment while the
tool is in use.
5.1 Connecting the compressed-air supply
NOTE
A set of connectors for connecting the tool to various
compressed-air systems is available as an accessory.
DANGER
Do not exceed the maximum input pressure of 8
bar (116 PSI). The compressed air must be filtered
and dry. Apply a drop of acid-free compressed-air oil
to the inside of the compressed-air connector each
day.
6.2 Inserting the cartridge in the tool 3
WARNING
Risk of pinching the fingers! Keep your hands away
from the area of the pressure pistons.
1.
Press the piston retraction button and allow the
piston rods and pistons to retract fully.
2.
Open the latch at the front end of the cartridge
holder.
3.
Grip the cartridge by the small cylinder and lay it
vertically in the cartridge holder.
4.
Close the latch.
6.3 Dispensing 4
DANGER
Never point the tool toward yourself or other per-
sons.
CAUTION
The initial quantity of mortar dispensed is not suit-
able for use. The quantity that must be discarded is
product-specific and is indicated in the applicable
Advertisement
Table of Contents
