Specified Conditions Of Use; User Groups; Care And Maintenance - Weller WXP 65 Translation Of The Original Instructions

Faults and defects must be repaired immediately.
Before using the unit / tool, safety devices must be carefully
checked to make sure that they are functioning properly and
in the manner intended. Check that moving parts are func-
tioning properly and are not sticking, and whether parts are
damaged. All parts must be correctly fitted and must satisfy
all the requirements necessary to guarantee troublefree
operation of the unit.
Use the correct tool. Use only accessories or auxiliary de-
vices which are included in the list of accessories or appro-
ved for use by the manufacturer. Use WELLER accessories
or auxiliary devices on original WELLER equipment only. The
use of other tools and other accessories can cause injury.
Secure the tool. Use clamping fixtures to hold the
workpiece.
Use a solder fume extraction unit. If appliances for
connecting solder fume extraction units are available, ensure
that they are connected and used properly.

Specified Conditions Of Use

Use the soldering iron exclusively for the purpose indicated
in the Operating Instructions of soldering and desoldering
under the conditions specified here.
WARNING
WXDP 120 (Robust), WXDV 120
Flammable gases and liquids may not be extracted.
The device may only be used with correctly fitted and
suitable filter cartridges.
Replace filter cartridges when full.
The soldering iron may only used in combination with Weller
Supply Units.
This device may only be used at room temperature and
indoors. Protect against moisture and direct sunlight.

User groups

Due to differing degrees of risk and potential hazards, sever-
al work steps may only be performed by trained experts.
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Filter change
Operation
Filter change
Replacing electrical repla-
cement parts
User groups
Specialist personnel with
technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the
guidance and supervision of
a trained expert

Care and maintenance

WARNING
Before doing any work on the machine, pull the
plug out of the socket. Leave the unit to cool down.
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
Do not use blocked nozzles.
Repairs must always be referred to a
Weller-trained specialist.
Use original replacement parts only.
WARNING Risk of burns
Only replace the soldering tips when they are cold.
•
Replace and clean suction nozzles only when hot and
•
using the suitable tool
Only replace hot air nozzles using the suitable tool
•
Only clean or replace solder collection tubes when cold
•
Soldering iron: The soldering tool must be left switched off
in the safety rest for at least 3 minutes until the soldering
tip has cooled down. The LED status indicator must be at
„OFF".
Desoldering iron: Replace the suction nozzles when warm
using the PDN desoldering nozzle pliers. For safety reasons,
we recommend that the desoldering iron be cleaned only
when cool.
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Filter change
WXDP 120 (Robust), WXDV 120:
To ensure that the filtration system functions properly, the filter
must be replaced as follows:
at least once a year or
•
when indicated or
•
as per maintenance schedule
•
Contaminated filters must be treated as special waste.
Dispose of replaced equipment parts, filters or old
devices in accordance with the rules and regulations
applicable in your country.
Wear suitable protective gear.
EN
ENGLISH
27