User Groups; Care And Maintenance; Specified Conditions Of Use; Warranty - Weller WT 2M Manual

Store your soldering tool in a safe place. When not in
use, units and tools should be stored in a dry, high or locked
area out of the reach of children. Make sure that unused
soldering tools are free of voltage and de-pressurised.
The power cable must only be plugged into the power
socket or adapter approved for this purpose. Check to
see if the mains voltage matches the ratings on the
nameplate. Make sure the machine is switched off before
plugging in.
Do not use the cable for purposes other than those for
which it is intended.Never carry the unit by the cable. Do
not use the cable to pull the plug out of the socket. Protect
the cable against heat, oil and sharp edges..
Be alert. Pay attention to what you are doing. Be smart
when using the unit. Do not use the soldering tool if you are
having difficulty concentrating.
Avoid abnormal posture. Arrange your work station in an
ergonomically correct way. Avoid bad posture when using the
unit, as this can lead to postural problems.
The soldering tool must be operated only in perfect
technical working order. Safety devices must not be
deactivated.
Faults and defects must be repaired immediately.
Before using the unit / tool, safety devices must be carefully
checked to make sure that they are functioning properly and
in the manner intended. Check that moving parts are func-
tioning properly and are not sticking, and whether parts are
damaged. All parts must be correctly fitted and must satisfy
all the requirements necessary to guarantee troublefree
operation of the unit.
Use the correct tool. Use only accessories or auxiliary de-
vices which are included in the list of accessories or appro-
ved for use by the manufacturer. Use WELLER accessories
or auxiliary devices on original WELLER equipment only. The
use of other tools and other accessories can cause injury.
Secure the tool. Use clamping fixtures to hold the
workpiece.
Use a solder fume extraction unit. If appliances for
connecting solder fume extraction units are available, ensure
that they are connected and used properly.

Specified Conditions Of Use

Supply unit for WELLER soldering tools. Use the soldering
station only for the purpose of soldering, as specified in the
Operating Instructions.
This device may only be used at room temperature and
indoors. Protect against moisture and direct sunlight.

User groups

Due to differing degrees of risk and potential hazards, sever-
al work steps may only be performed by trained experts.
Work step
Default soldering para-
meters
Replacing electrical repla-
cement parts
Default maintenance
intervals
Operation
Operation
Replacing electrical repla-
cement parts

Care and maintenance

WARNING
Before doing any work on the machine, pull the plug out
of the socket. Leave the unit to cool down.
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
Repairs must always be referred to a Weller-trained
specialist.
Use original replacement parts only.

Warranty

Clams by the buyer or physcal deects are tme-barred
ater a perod o one year rom del v ery to the buyer. Ths
does not apply to clams by the buyer or indemnification n
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
We shall only be l a ble or clams arsng rom a warranty
urnshed by us the qual t y or durabl t y warranty has been
urnshed by use n wrtng and usng the term „Warranty".
The warranty shall be vod damage s due to mproper use
and the devce has been tampered wth by unauthorsed
persons.
User groups
Specialist personnel with
technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the
guidance and supervision of a
trained expert