Advertisement
Technical Data
Power consumption
Mains supply
Heat-up time
(50°C - 350°C) (120°F - 660°F)
Temperature max.
Safety information
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory
or mental capabilities or lack of experi-
ence and knowledge if they have been
given supervision or instruction concer-
ning use of the appliance in a safe way
and understand the hazards involved.
Children shall not play with the appli-
ance.
Cleaning and user maintenance shall
not be made by children without super-
vision.
Specified Conditions Of Use
Only use the soldering/cutting tool for the purpose specified
in the operating instructions, i.e. for soldering and as a hot
knife for materials such as polystyrene and PVC.
The manufacturer shall not be liable for damage resulting
from misuse of the product or unauthorized alterations.
WARNING
Fire and explosion hazard! Risk of
burns!
Do not touch the hot soldering tips and keep them away
•
from inflammable objects.
After the soldering process, the soldering tool and the
•
workpiece holder are still hot.
Risk of burns may occur when solder is molten!
•
Keep explosive and flammable objects well away from the
•
device.
Only replace solder tips when cold
•
Avoid unintentional operation.
•
WLG9400
140 / 100 W
The soldering tip becomes very hot during soldering
230V~
work. There is a risk of burns from touching the tips.
50Hz
After the soldering process, the soldering tool and the
6 seconds
workpiece holder are still hot.
•
900 °F / 480 °C
•
•
Risk of burning through liquid solder. Protect yourself
against solder splashes.
•
•
•
•
Wear appropriate protective clothing to protect yourself
against burns. Protect your eyes by wearing eye protection.
Do not use the soldering tool in a damp or wet environment.
Never work on voltage-carrying parts.
The soldering tool must be operated only in perfect technical
working order.
Avoid unintentional operation. Disconnect the soldering tool
from the power supply while not in use.
The power cable must only be plugged into the power socket
or adapter approved for this purpose. Check that the power
supply voltage is compatible with the connected load of the
soldering iron.
Before use check machine, cable, and plug for any damages
or material fatigue.
For product service, contact the corresponding Customer
Service location found in this manual
If the electrical tool's power supply cord is damaged, it must
be replaced with a specially prefabricated power supply cord
available through the customer service organisation.
Trouble Shooting
If tool fails to heat, remove and clean connecting ends of the
tip, replace and tighten thoroughly. After cleaning and re-
tightening, depress the trigger and allow to heat for 15 sec.'s.
Release the trigger and retighten again
WARNING
Risk of burns
Always place the soldering tool in the safety rest while not
in use. Make sure the safety holder is stable.
Do not touch the hot soldering tips and keep them away
from inflammable objects.
Only replace solder tips when cold
Wear appropriate protective clothing to protect yourself
against burns. Protect your eyes by wearing eye
protection.
When working with adhesives, special attention must be
paid to the warning information provided by the adhesive
manufacturer.
WARNING
Electrical shock
Do not use the soldering tool in a damp or wet environ-
ment.
Never work on voltage-carrying parts.
EN
ENGLISH
7
Advertisement
