Switching The Positions Of The Display Unit And The Battery Compartment - Seca 777 Instructions For Use And Warranty

Switching the positions of the
display unit and the battery
Left-hand
operating side
8. Connect the connecting cable:
9. Set the measuring station in an upright position.
At the factory, the display unit is fitted to the right-hand operating side of the
display head. The battery compartment is on the left-hand operating side.
compartment
Proceed as follows to switch the positions of the display unit and the battery
compartment.
Right-hand
operating side
1. Remove the cover panel:
2. Remove the battery compartment lid:
NOTICE!
Damage due to assembly faults
If the cables are bent at too sharp an angle, they may be damaged
and thus cause a functional failure.
► Route all cables to prevent sharp bends and kinked connectors.
a) Draw the connecting cable out of the column
b) Route the connecting cable past the cable clip and insert in the
socket on the weighing platform
c) Fix the connecting cable in position with the cable clip
a) Unscrew two cross-head screws
b) Remove the cover panel
a) Hold the battery compartment lid steady
b) Remove the cross-head screw behind the battery compartment lid
c) Remove the battery compartment lid
English
Starting up device • 17