Star Trac UB Sport Upright Bike Owner's Manual page 13

CAUTION: Be careful not to pinch your fingers between the console neck
and the bike frame when sliding the console into place.
CAUTION: Be sure not to pinch the display cables between the console
neck and the bike frame.
While gently pushing the display cables up into the display console
neck, carefully slide the console neck onto the neck brackets until it is
fully seated. Secure the display console to the bike frame with four M6
X 16 flat head screws (two screws in front side and two screws in back
side). Tighten all four screws securely.
4. Install the Seat Post
Carefully slide the seat post and seat tube into the seat tube on the bike
frame. Make sure the seat tube is fully bottomed against the frame.
Install the M6 X 10 socket head screw into the hole in the back of the
seat tube. Tighten the screw securely.
Pull out on the seat release knob, and slide the seat post fully into the
seat tube. Release the seat release knob.
5. Install the Pedals
NOTE: Turn the left pedal spindle counterclockwise when
threading into the crank arm; turn the right pedal spindle
clockwise when threading into the crank arm.
Install the pedals on the pedal cranks using a 5/8-inch open-end
wrench. Tighten the pedals securely.
6. Leveling the Bike
Place the bike on the floor in the position in which it will be used. Use the leveling adjusters (located on the underside of
the front and rear feet) to compensate for uneven floor surfaces and to eliminate wobbling.
You have now completed assembly of your STAR TRAC UB / Ubx SPORT UPRIGHT BIKE.
STAR TRAC SPORT BIKES O ' M
WNER S ANUAL
Step 3d
Step 4
Step 5
13