Table of Contents
Advertisement
1MRS751270-MEN
5.6
5.7
ABB Automation
Installation and Commissioning Manual
•
'Abort', which aborts the installation immediately. Note! Your computer
configuration has not yet been modified at this point, so you can safely select this
option to exit installation.
•
'Retry', which checks the disk space and redisplays this dialog box if the amount
of available disk space has not increased sufficiently. Otherwise, the software
installation continues normally.
•
'Ignore', which causes the installation blindly to continue copying the software to
the destination. Notice that it is not recommended to use this option as the
installation might eventually fail in its operation.
No suitable destination drive available
If your computer does not contain any drives formatted to NTFS and you have not
installed CAP 501 v. 2.0.0 before, the installation displays the message shown in
Figure 28.
Figure 28. No suitable destination drive available for installation.
Click 'OK' to dismiss the message and to exit the installation.
In order to install CAP 501, you must format a drive to NTFS. You can use the
Windows NT Disk Administrator to accomplish the task, for more information on
formatting disks in Windows NT refer to the Disk Administrator's help and/or any
applicable guide on using Windows NT.
Incompatible SYS 500 and/or COM 500 installed
During the start-up of the installation, you may see the notification displayed in Figure
29.
CAP 501
Troubleshooting
35
Advertisement
Table of Contents
Troubleshooting
