ABB CAP 501 Installation And Commissioning Manual page 23

Installation and Commissioning Manual CAP 501
1MRS751270-MEN
Installation
Figure 8. The 'Destination Drive' dialog box.
All disk drives available to the operating system are listed in the drive list (highlighted
in the above figure). Also the amount of available and required hard disk space are
shown on the lower right area of the dialog box.
Press the <F4> key from the keyboard or click on the arrow head on the right side of
the drive list to view it in the drop-down mode. You can use either the arrow keys on
the keyboard or the mouse to select a drive from the list.
As you change the selection, the installation checks whether the drive can be used for
installing the software. If it can not be used, you will see a notification message and
the drive that was selected at the time of entering the dialog box, is reset as the
destination drive. The possible notifications are described in more detail in section 5.4.
To use the selected drive and to return to the 'Select' dialog box click 'OK'. Otherwise,
click 'Cancel' and the changes to the destination drive will be discarded as you return
to the 'Select' dialog box.
ABB Automation
23