Led Display - Star Micronics TSP800 Series User Manual

I Initializing Settings
Set the push switch as described below to initialize the setting information.
Push the switch for one to five seconds while running under normal operating
mode. The green and red LEDs will flash with a regular pattern. After that, push
the switch once again in that state to turn OFF both of the red and green LEDs.
This will return the settings of the interface board to their default, or ex-factory,
settings. After the interface board has been initialized, the printer will automati-
cally reboot itself.
I LED Display
Green : Lights when other party connection is recognized as 100BASE-TX.
Red : Lights when packets are received.
I Printer Driver / Utility software / LPR Port Driver
The printer driver, utility software and LPR port driver can be downloaded from
the following website.
Printer Driver URL : http://www.star-m.jp/eng/dl/dl02.htm
LPR Port Driver
<Windows 95/98 ME>
To use the Ethernet interface from Microsoft's Windows 95/98 and ME, the
"Star LPR Port Driver Set" along with the printer driver is necessary.
Download the Star LPR Port Driver Set from the above Web site.
<Windows XP/2000>
To use Windows NT 4.0/2000/XP, the "Star LPR Port Driver Set" is
unnecessary.
Add a "Standard TCP/IP port".
This driver allows the use of both "Raw" and "LPR" protocols.
"LPR" is recommended for normal use.
To use LPR, set the following.
Key Name:
Enable LPR Byte Count: Enable
1p
– 117 –