B-3. Usb Interface Type - Star Micronics TSP800 Series User Manual

B-3. USB Interface Type

ON
OFF
No. 1 2 3 4 5 6 7 8
DIP-SW1
Switch
1-1 Command emulation (Ster Line mode)
1-2 Command emulation (Ster Line mode)
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 USB mode (See below) *1
1-6 USB mode (See below) *1
1-7 Automatic status back function *2
1-8 Should not be changed (Should be set to on)
USB Mode settings are enabled only when the firmware of the USB interface
*1
board is USB 2.00 or later.
Automatic status back function is disabled when USB mode is 0.
*2
The factory settings of DIP switch are all on.
Switch 1-5
ON
OFF
ON
OFF
Switch
2-1~2-4
The factory settings of DIP switch are all on.
I Printer Driver
The printer driver and vendor class driver can be downloaded from the following
website.
Printer Driver URL : http://www.star-m.jp/eng/dl/dl02.htm
DIP-SW 1
Function
Switch 1-6
ON
ON
OFF
OFF
DIP-SW 2
Function
Always ON
– 115 –
ON
OFF
No. 1 2 3 4
DIP-SW2
ON
Always ON
Always ON
Invalid
Invalid
USB Mode
Mode 0 (Printer class old)
Mode 2 (Vendor class)
Mode 1 (Printer class new)
(Reserved)
ON
Should be set to on
OFF
Valid
Valid
OFF