A-2. Auto Cutter Specifications; A-3. Interface; A-4. Electrical Characteristics - Star Micronics TSP800 Series User Manual

A-2. Auto Cutter Specifications

(1) Cutting frequency
(2) Thickness of paper

A-3. Interface

RS-232C serial interface/Two-way parallel interface (IEEE1284)/USB inter-
face/Ethernet interface/Wireless LAN Interface

A-4. Electrical Characteristics

(1) Input Voltage
(2) Current Consumption Operating: Approx. 1.8 A (at ASCII printing)
(3) Power Connector
Pin No. Function
1 Drive power
2 Signal GND
3 N.C.
Shell Frame ground
Important!
• When using a printer power supply other than the optional AC adaptor
(PS60), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ±10% and more than 2.0 A (5.0 A Load
10 sec. Min) with SELV output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise.
Take the appropriate measures to protect against electrostatic AC line
noise, etc.
Max. 20 cuts per minute
0.065 ~ 0.15 mm
DC 24V±10%
Peak: Approx. 10 A (at print duty 100%,
for 10 seconds or less)
Stand-by: Approx. 0.1 A
<Viewed from Connector Surface>
– 106 –
3
1
2