Adjusting The Near-End Sensor - Star Micronics TSP800 Series User Manual

Use the following procedure to adjust the near-end sensor so it is compatible with
the size of roll paper you are using.
1 Open the printer cover.
2 Determine the diameter of the roll paper you are using and find the required
setting in the table below.
3 Insert the tip of a ballpoint pen or similar pointer object into the hole of the
adjuster. While pressing the adjuster, slide it up or down to the setting that
matches the roll paper you are using.
Make sure the tab indicated by the arrow in the illustration is inside one of the
grooves.
Level 3
Level 2
Level 1
Important!
The wall mount model can only be used at level 3, and therefore must not
be modified. Make the necessary adjustments to the standard model.

6. Adjusting the Near-end Sensor

– 21 –