Table of Contents
Advertisement
Advanced Device Configuration
Front Panel Keys
There are three programmable buttons on the buttons bar. The
programming
"\Utilities\Utilconfig.cfg" file as well as with the GUI described in
UtilConfig Editor on page
following functions:
•
PWR – Starts & shutdowns the terminal depending on the
current Startup/Shutdown mode.
•
1 – Up arrow.
•
KEY – Display/remove the soft keyboard from the screen.
Normally the PWR and KEY buttons should not be reprogrammed,
but they are available if required.
Configuration
The listed values are the default values from the factory. Setting
PWR and KEY to blank causes them to execute Startup/Shutdown
and Softkeyboard respectively. The VK values for each key are listed
in the SoftKeyboard section of this document. Multiple values can be
entered for a key by using comma to separate the values. For
example, the definition
would cause the S1 key to transmit tab, then a return key.
•
Frontkey_PWR=
•
Frontkey_S1=#EXT=VK_UP
•
Frontkey_S2=
•
Frontkey_S3=
•
Frontkey_S4=
•
Frontkey_KEY=
48
is
set
by
37. The configurable buttons have the
Frontkey_S1=#EXT=VK_TAB,VK_RETURN
command
lines
in
the
TaskBook
Advertisement
Table of Contents
