Hazards During Electrical Connection - Datalogic TaskBook User Manual

Safety Instructions

Hazards during electrical connection

Products with DC/DC power supply
The product must be operated with a Safety Extra Low Voltage
(SELV) according to IEC60950-1.
Products with AC power supply
The product may only be connected to an earthed safety plug.
Separator
The standby key does not disconnect the device from the mains
voltage. For complete disconnection from the mains voltage, the
mains cable must be unplugged or a suitable separator must be
installed. Make sure it disconnects all supply lines.
Power Cables
Do not use damaged power cables. Damaged power cables may
cause electric shock or fire. Observe country-specific regulations
when installing the cables. Make sure that the power cable is not
damaged by mechanical interferences.
Only use original power cables from Datalogic. These meet the
special requirements for cold temperature flexibility, UV resistance
and oil resistance. If other cables are used, the operator is liable for
any resulting damage. In addition, any warranties expire.
Charging the internal battery
Either the product must be disconnected from the internal battery
during charging, or it must be ensured that the product's maximum
allowed input voltage is not exceeded.
User's Manual 5