ChargePoint Home FlexCharfePoint Installation Manual page 2

Important Safety Instructions
SAVE THESE INSTRUCTIONS
WARNING:
When using electric products, always follow basic precautions, including
the following.
1. Read and follow all warnings and instructions before installing and
operating the ChargePoint® charging station. Install and operate only as
instructed. Failure to do so may lead to death, injury, or property damage,
and will void the Limited Warranty.
2. Only use licensed professionals to install your ChargePoint® charging
station and adhere to all national and local building codes and standards.
Before installing the ChargePoint® charging station, consult with a licensed
contractor, such as a licensed electrician, and use a trained installation
expert to ensure compliance with local building and electrical codes and
standards, climate conditions, safety standards, and all applicable codes
and ordinances. Inspect the charging station for proper installation before
use.
3. Always ground the ChargePoint® charging station. Failure to ground
the charging station can lead to risk of electrocution or fire. The charging
station must be connected to a grounded, metal, permanent wiring
system, or an equipment grounding conductor shall be run with circuit
conductors and connected to the equipment grounding terminal or lead
on the Electric Vehicle Supply Equipment (EVSE). Connections to the
EVSE shall comply with all applicable codes and ordinances.
4. Install the ChargePoint® charging station using a ChargePoint
approved method. Failure to install on a surface that can support the
weight of the charging station can result in death, personal injury, or
property damage. Inspect the charging station for proper installation
before use.
5. This charging station is not suitable for use in hazardous locations. Do
not install Home Flex near flammable, explosive, or combustible materials.
6. This device should be supervised when used around children.
7. Do not put fingers into the electric vehicle connector.
8. Do not use this product if the flexible input power cable or EV charging
cable is frayed, has broken insulation, or any other signs of damage. Call
ChargePoint customer support immediately at 1.888.758.4389.
9. Do not use this product if the enclosure or the EV connector is broken,
cracked, open, or shows any other indication of damage. Call
ChargePoint customer support immediately at 1.888.758.4389.
10. Use 90°C wire copper conductors only.
11. Do not operate Home Flex in temperatures outside its operating
range. For charging stations set to 16-48 A, the range is -40˚F to 122˚F
(-40˚C to 50˚C). For charging stations set to 50 A, the range is -40˚ to
113˚F (-40 to 45˚C).
2 chargepoint.com
This manual contains important instructions for Home Flex.