Connect The Printer To The Computer; Connect The Printer's Power Cord; Loading Single Sheets; Mount The Paper Guide - Star Micronics LC24-10 User Manual

Connect the printer to the computer
Connect the printer end of the interface cable to the connector socket
on the right side of the printer as shown in Figure l-6.
Make sure the computer is turned OFF, then connect the other end
of the cable to your computer as described in the computer manual.
cable
Connect the printer's power cord
Check that the printer's power switch (located at the left front) is OFF.
Then plug the printer's power cord into an AC wall outlet.
Never plug or unplug the power cord while the printer is turned on.
LOADING SINGLE SHEETS
This section will take you through the procedures for loading single
sheets of paper.
If you are using the optional automatic sheet feeder (ASF), read the
ASF instruction booklet.
Mount the paper guide
The paper guide tits into the two holes on top of the rear cover. Mount
the guide and raise it to the upright position.
6