Star Micronics NX-1000 User Manual page 92

Define download characters
1 Mode I ASCII
I
Decimal
I
Hexadecimal
I
tl-
IBM
<ESC> "="
nl n2 27 38 nl n2
1B 26 nl n2
<DC4>
a0 al a2 20 a0 al a.2 14 a0 al a2
ml m2 .-ml1 ml m2 . ..mll ml m2 . ..mll
Defines one or more new draft characters and stores them in RAM for
later use. Draft mode must be selected before this command is executed.
nl and n2 give the number of bytes of character data that will follow.
a0 is the character code of the first character defined. al and a2
are at-
tributes bytes. ml to ml1 are the character data, and are the same as in
< ESC > "&." The attribute byte al indicates whether the character is
an ascender (not using the lowest of the nine vertical dots) or a descender
(not using the highest dot) and whether it has a downward extension to
12 dots.
The attribute byte a2 gives proportional-spacing information. Bit 7 is
ignored. Bits 4 to 6 specify the offset to the first byte printed (0 to 7),
enabling leading spaces in the character to be ignored. Bits 0 to 3 specify
the width of the character cell (maximum 11 dots). The character will
be followed by a mandatory blank dot column which is not included in
this width.
Characters defined by this command can be selected by < ESC > "%"
1, < ESC > "I" 4, < ESC > "I" 5, or < ESC > "I" 6. This command is
ignored when DIP switch 2-l is ON.
Select download character set
Mode ASCII
Decimal Hexadecimal
<ESC> '. y. 7. " 1"
27 37 49
IB 25 31
Both L
<ESC> "o/o" <I >
27 37 1
1B 25 01
Selects the download character set. Ignored when DIP switch 2-l is ON.
Select draft download character set
-.
IModel ASCII I
Decimal
I
Hexadecimal
I
< ESC > "1" "4"
27 73 52
IB 49 34
IBM
< ESC > "I"
<4>
27 73 4
1B 49 04
Selects the download character set and draft quality. Ignored if the NLQ
Type Style switch was pressed during power-up or if DIP switch 2-l is
ON.
84